Cardinal 748 - Page 18

17
ENTER
* If any components have been changed that affect calibration and your scale is used in a
commercial application and must be “Legal for Trade” you cannot use “C” numbers to re-calibrate.
Press to show the current settting. Press or
to enter the new setting and press to save it or
to save the current setting.
no (0) = Bar Graph readout is disabled YES (1) = Bar Graph readout is
enabled.
NOTE! If bAr= is set to NO, the BAR key is also disabled and
Error will display if the key is pressed.
1
0
ENTER
BAR GRAPH ENABLE/DISABLE
bAr=
ZERO TRACKING RANGE
4% ZERO RANGE
Press to show the current setting. Press through
to enter the new automatic zero tracking range. Then
press to save it or to save the current setting.
Allowable values are: 0.0 (disables Zero Tracking), .5 and 1 through 9.
Press to show the current setting. Press or
to enter the new limit for zero range. Then press to
save it or to save the current setting.
no = Full Capacity (No Limit) YES = 4% of Scale Capacity
0
trA=
trL=
0
9
ENTER
ENTER
ENTER
ENTER
1
POWER-UP ZERO FEATURE
FILTERING
Press to show the current setting. Press or
to enter the new setting and press to save it or to
save the current setting.
no = No Re-Zero on Power-Up YES = Automatic Re-Zero on Power-Up
Press to show the current setting. Press
through to enter the new filtering level. Then press
to save it or to save the current filter setting.
0 = No Filtering 2 = Moderate Filtering
1 = Minimal Filtering 3 = Custom Filtering
If you selected 0, 1 or 2, advance to
MOTION RANGE.
0
3
ENTER
1
ENTER
PUO=
FLt=
0
ENTER
ENTER