Cardinal 777 - Keypad Menu and Setup Keys; MENU Key Function; Setup and Application Keys

13
KEYPAD FUNCTIONS, CONT.
SETUP
Pressing this key with the calibration sealing screw removed, will change the screen to the
Setup or Adjust Menu (see Figure No 11). Pressing this key without
the calibration sealing
screw removed, will display an error message,
CAL SEAL PRESS ENTER. The Setup
or Adjust Menu contains the following selections:
SETUP
Press this key to start the Setup and Calibration procedure.
ADJ
Press this key to perform the Fine Span Adjustment (refer to step 13, Setup and
Calibration section).
EXIT
Press this key to start the Start Menu.
STD
Pressing this key will load and run the 777 standard weight indicating program. This
program is EPROM based, can not be changed and is always in the indicator. The
EPROM program allows the 777 (as it comes from the factory) to be used as a complete
indicator. NOTE: The STANDARD.BAS program included with the SmartWeigh software
development package is equivalent to the standard EPROM program.
APP
The application program is automatically loaded after approximately a five (5) second delay
when turning on the indicator or changing from setup, receive, etc. modes. Pressing this key
will bypass the delay and load and run your application program quicker.
LOAD
Pressing this key will start the procedure to load
an application program into the 777 from a
computer or another 777. See the LOADING and SENDING PROGRAMS section of this
manual for more information.
ESC
Press this key to abort the load procedure and return to the LOAD / SEND / DSPLY
Menu.
SEND
Pressing this key will start the procedure to send
the currently loaded application program
from the 777 to a computer or another 777. See the LOADING and SENDING PROGRAMS
section of this manual for more information.
ESC
Press this key to abort the load procedure and return to the LOAD / SEND / DSPLY
Menu.
DSPLY
This key is used to adjust the contrast of the LCD display. Pressing this key will change to
the contrast adjust screen. This screen will show a test pattern and a row of keys at the
bottom labeled, UP, PREV, NEXT and DOWN.
Press the UP key to increase the screen contrast.
Press the DOWN key to decrease the screen contrast.
Press the
PREV
or
NEXT
keys to return to the previous menu screen.