6
INSTALLATION, Cont.
Wall Mounting
The 777 can be mounted on the wall using two (2) #10 x 1 1/2" screws placed 5 1/2" apart.
To prepare the 777 for wall mounting, perform the following procedure:
1. With the power cord unplugged, remove
the four (4) screws securing the front
cover assembly to the main housing. See
Figure No. 1.
2. Lift front cover assembly from the main
housing, taking care not to stretch the
cable and wires between the front cover
and main housing excessively.
3. Locate the flat ribbon Parallel Internal Bus
(PIB) cable.
One end of the PIB cable is
plugged into the display board and the
other end is loose in the main housing.
Unplug the end of the PIB cable
connected to the display board.
Figure No. 1
4. Rotate the front cover assembly 180
degrees. See Figure No. 2.
5. Plug the end of the PIB cable that was
loose in the main housing into the display
board. Insure that no cables or wires are
exposed between the main housing and
front cover assembly and place the front
cover onto the main housing.
Figure No. 2
6. Secure the front cover to the main
housing with the four (4) screws removed
in step 1. See Figure No. 3.
Figure No. 3
To Next Page
Loading...
