7
INSTALLATION, Cont.
7. Turn the indicator on its side and remove
the rubber footpads from the bottom of the
main housing. See Figure No. 4.
8. With the front cover assembly rotated and
the footpads removed, what was the
bottom of the indicator is now the back of
the indicator. See Figure No. 5.
9. With the cable connections down
(towards the floor), place the large end of
the slotted hole in the back of the indicator
over the screw heads and gently pull
down to secure the indicator.
See Figures No. 6 and 7.
Figure No. 4
Figure No. 5
Figure No. 6
Figure No. 7
To Next Page
Loading...
