Cardinal 777 - Program Sending Procedure; Sending Application Programs

20
LOADING AND SENDING ROGRAMS, Cont.
Load A Program, Cont.
15. When the 777 is finished loading (receiving) the program, the screen will display
DONE. Press the
OK
key to return to the LOAD / SEND / DSPLY Menu, then press
the NEXT key twice to load and run the program.
NOTE:
To load and run your program quicker, press the
NEXT
key twice, then press
the APP key. This will bypass the five (5) second delay at the Start Menu.
Send A Program
The steps to send an application program to the 777 are as follows:
1. Apply power to the 777 indicator.
2. While the Start Menu is displayed, press the NEXT key. The screen will change to the
LOAD / SEND / DSPLY Menu.
3. Press the
SEND
key.
4. The screen will display,
SELECT COM 1 OR COM 2.
5. Press the COM1 key or the COM2 key depending on which port you are using to send
the program OR press the
ESC
key to abort the send procedure and return to the
LOAD / SEND / DSPLY Menu.
6. The screen will display,
SEND? and the current baud rate selected.
• If the baud rate displayed is correct, press the YES key to continue.
• If the baud rate displayed is incorrect or you wish to use a different rate, press the
BAUD
key. The screen will display the next baud rate available. Continue
pressing the BAUD key until the desired baud rate is displayed. Press the YES
key to continue.
• When the
NO
key is displayed, the load procedure may be canceled. Pressing the
NO
key will display,
CANCELLED LOCALLY. Press the
OK
key to return to the
LOAD / SEND / DSPLY Menu.
7. Make sure the remote (the computer or another 777 indicator) is ready and press the
YES
key to start sending. The screen will display
SENDING TO COMx (x = the
com port selected in step 5), the record number the indicator is sending and a status
message.
8. To stop or pause the send process, press the
ESC
key. The screen will display
QUIT?.
• To stop sending the program, press the
YES
key. The screen will display,
CANCELLED LOCALLY. Press the
OK
key to return to the
LOAD / SEND / DSPLY Menu.
• Press the
NO
key to continue sending the program from the point at which it was
interrupted.
9. When the 777 is finished sending the program, the screen will display
DONE
. Press
the
OK
key to return to the LOAD / SEND / DSPLY Menu, then press the
NEXT
key
twice to load and run the program.
NOTE:
To load and run your program quicker, press the
NEXT
key twice, then press
the
APP
key. This will bypass the five (5) second delay at the Start Menu.