8526-M260-O1 C Series Operation
5
ANNUNCIATORS
lb
The lb annunciator is illuminated to show that the weight displayed is in pounds. The UNITS
key may be used to select pounds as the weighing units.
kg
The kg annunciator is illuminated to show that the weight displayed is in kilograms. The
UNITS key may be used to select kilogram as the weighing units.
NET
The NET annunciator is illuminated to show that the weight displayed is the net weight. Net
weight is determined by subtracting the stored tare weight from the gross or scale weight.
The tare weight, usually the weight of the container, is entered using the tare key. Note that
the NET annunciator is only active when a zero tare weight or tare weight value is stored
and the display is in the weight mode as shown by the illumination of the lb or kg
annunciator.
ZERO (Center-of-Zero)
The Center-of-Zero annunciator is located on the left of the display and is illuminated to
indicate that the weight is within +/- 1/4 division of the center of zero.
Insuf Sample
The Insuf Sample annunciator is located on the lower left of the display and is illuminated to
show that the sample is too small to calculate an accurate piece weight. If the counting
function is continued without
increasing the sample size, the scale will still operate even
though accuracy will be affected.
(Stable)
The (Stable) annunciator is located at the bottom left of the display and is illuminated when
the WEIGHT display is stable.
ADD
The ADD annunciator is located at the bottom right of the display and is illuminated when
the scale is in the accumulator mode (M+).
M+
The M+ annunciator is located on the lower right of the display and is illuminated to show
that the display is in the Accumulator mode and that the value displayed is the current
contents of the accumulator. Individual counts are adjusted via the ( M+ ) and ( MC ) keys
or optionally, any count may be entered using the numeric keypad. Note that when both the
M+ and ADD annunciators are illuminated, the current count has been added to the
accumulator.
(Low Battery)
The Low Battery annunciator will illuminate to indicate that the internal battery requires
charging. No change in operation will occur until just before the battery voltage drops to a
level where operation is affected. At this level, the scale will automatically turn itself off.
NOTE! When the battery needs to be recharged, the CHARGING LED will turn Red. After
the battery has been recharged, the CHARGING LED will turn Green.
To Next Page
Loading...
Need help?
General