Cardo Systems PACKTALK - 5.3 BUSY SIGNAL; 5.4 RECEIVING INTERCOM CALLS

5.2c CLICKTOLINK CTL INTERCOM MODE
Click-to-Link is a spontaneous way to instantly initiate 1-on-1 intercom calls
with other riders near you, without being paired. Think of it as a private channel
that you can set up on-the-go with other riders that you see along the way.
Click-to-Link can be disabled eectively blocking any attempt by a third party to send a
CTL request to you.
Start a CTL call request
(search lasts up to 10 sec.)
In Standby, press
v
for 2 seconds
End a CTL call /
Cancel a CTL call request
Tap
v
Accept a CTL call
When hearing the CTL ringtone: Tap
v
or say any word loudly
to answer by VOX
Reject a CTL call
While hearing the CTL ringtone, remain silent until the ring tone
stops, or press
v
for 2 seconds
Enable / Disable CTL
(Enabled by default)
See section 3
If other riders are nearby, your next Click-to-Link call may randomly connect to any of them.
5.3 BUSY SIGNAL
When attempting to establish an Intercom call with another device that is already busy,
a “busy” signal will be heard. The scala rider is busy while on a phone call, intercom call
with Channels “A” and “B”, “1+8” intercom call or CTL call.
5.4 RECEIVING INTERCOM CALLS
If a paired unit tries calling you via Intercom, the call will begin almost instantly.
24 |