6. USING A MOBILE PHONE, GPS OR MP3 PLAYER
To use a Bluetooth device with your scala rider PACKTALK you must rst pair them.
Once paired, they will automatically recognize each other whenever they are within
range (10m / 33ft).
Your scala rider has two Bluetooth channels to connect mobile phones, GPS devices
and music players with A2DP.
6.1 PAIRING BLUETOOTH CHANNELS 1 AND 2
1. Make sure Bluetooth is enabled on your phone/GPS/MP3 player.
2. To pair Bluetooth Channel 1 – In Standby, press
p
for 5 seconds until the RED and
BLUE LEDs begin rapidly alternating.
To pair Bluetooth Channel 2 – In Standby, press
π
for 5 seconds until the RED and
BLUE LEDs begin rapidly alternating.
To pair a GPS, when LEDs begin rapidly alternating, roll the
Z
either
forward or back.
3. Search for Bluetooth devices on your phone/GPS/MP3 player by following the
device’s instructions.
4. After a few seconds the device will list your name or “PACKTALK”. Select it.
5. If prompted for a PIN or Passkey, enter 0000 (four zeros).
6. The device will conrm that pairing has succeeded and your unit will return to
Standby mode, LED ashing once every 3 seconds.
7. If pairing is not completed within 2 minutes, the unit will return to Standby mode.
|
25
To Next Page
Loading...
