4.3 PARALLEL AUDIO STREAMING AND AUDIO SOURCE PRIORITIES
The scala rider PACKTALK can stream audio from two connected sources
simultaneously, so that you can listen to your music or the radio while holding an
intercom conversation. Parallel Audio Streaming is automatically disabled during
mobile phone conversations.
By default, Parallel Audio Streaming is enabled. See section 3 to adjust the settings.
If disabled, the scala rider will automatically determine which audio source to play
based on the priority of the connected devices.
Higher Priority
1. Mobile Phone or GPS instructions
*
2. Intercom (DMC and Bluetoo th modes)
3. A2DP (Stereo Bluetooth) audio
4. FM Radio (Built-in)
*GPS instructions from Smartphone GPS Apps are prioritized
like A2DP audio
Lower Priority
A2DP audio priority can be congured to be higher than Intercom. See section 3 to adjust
settings.
• Incoming mobile phone calls interrupt ongoing intercom calls
• Incoming intercom calls will interrupt FM radio
• Intercom modes all have the same priority - ongoing intercom calls will not be
interrupted by any other intercom call
4.4 VOICE COMMANDS
The Voice Commands allow you to perform certain actions by simply using your voice.
Using advanced Voice Recognition, you can control the PACKTALK completely handsfree.
The default Voice Command language is English. Other languages are also available -
see section 3 to adjust settings.
Throughout this manual, features which are available via Voice Command are marked
with the
ß
icon.
1. With no call in progress, tap
Z
or speak any word loudly to activate VOX
2. Speak a Voice Command from the table:
10
|
To Next Page
Loading...
Need help?
General
