b. On both units press the Channel ”B” Button until the lights are
ashing rapidly in Blue indicating that Rider “B” and Rider “C” are
in Pairing mode.
c. Within a few seconds, both G4s will show a solid light for two
seconds, indicating that they are now paired, connected and
ready for use.
d. Turn on Rider “A” unit and wait until it reconnects to the factory
paired Rider “B” unit.
NOTE: If units “A” and “B” don’t reconnect automatically, press the
Channel “A” Button on Rider “A” unit and connect manually.
Initiate Intercom calls
There are two ways to start an Intercom call with your paired G4s while the
G4 is in Standby mode:
VOICE CONNECT:
Start talking loudly
Once you start talking loudly, an
Intercom call will be established with
both paired G4s, CHANNEL “A” and
CHANNEL “B” (if both are available).
CHANNEL BUTTON
CONNECT:
Single tap the CHANNEL “A”
or "B" Button to add or remove
the chosen channel from an
Intercom call.
9.10c. FOUR-WAY INTERCOM
When connected to three other G4 units, your G4 can also
participate in a 4-way Conference Intercom Call (full duplex) as
explained below.
Please note that the 4-way conference operates in a linear manner,
whereby the two passengers serve as the connecting links for the
entire group. Therefore, if one of the Passengers disconnects, the
4-way conference mode will be interrupted until that passenger is
reconnected.
4-Way Intercom between up to two couples on two motorcycles
two drivers (1 and 3) and two passengers (2 and 4)
In this conguration the two passengers (numbered 2 and 4) are each
using two Bluetooth connections:
Passenger 2 is paired to Driver 1 and to Passenger 4
Passenger 4 is paired to Driver 3 and to Passenger 2
IMPORTANT: Since both Passengers each use two Bluetooth connections
during the conference mode, they will both be disconnected from their
mobile phones until the conference mode is terminated. Upon termination,
both Passengers will automatically re-connect to their mobile phones. Both
Drivers 1 and 3 remain connected to their mobile phones or GPS devices
during the 4-way intercom call.
PAIRING FOUR SCALA RIDER G4s
To converse in the 4-Way intercom conference mode, the four G4s
must be paired as shown in the biker illustration above. All four units
should initially be turned o.
Step One: Pair Driver 1 to Passenger 2 via Channel “A” as follows
a. Turn both G4s ON by pressing and holding the Mobile Buttons
until the Blue Light ashes three times.
b. Both G4s should now be ashing slowly in Blue.
18
scala rider
®
G4
PowerSet
To Next Page
Loading...
Need help?
General
