CareCo Corvus Rapide - Charging the Batteries; Charger Operation and Indicators

20
6.CHARGING THE BATTERIES
6.1 OPERATING THE CHARGER
Batteries must be charged before using the scooter for the rst time and should be
recharged after each day use. You will need the scooter and the battery charger.
» Each country may supply dierent charger.
» The charging procedure may be dierent from
below.
» If you require more details, please contact your
authorized dealer.
» Be sure the scooter key is in the OFF position.
» Do not use extension cord to connect the charger.
» Do not use other brand charger to charge the
scooter.
1. Insert battery charger cord into the charger connector on the charger output. Refer to above
gure for correct position
2. Plug the other end of the battery charger cable into a standard electrical outlet.
3. Turn the power on. Normally, The LED (Power) Light will turn on when electric current passes.
4. Charging starts. During charging, LED (Charge) will indicate orange light, when it turns to green
light, that means well-charged.
5. LED indication
» LED(POWER) - GREEN LIGHT ON : Power On.
» LED(CHARGE) - ORANGE LIGHT ON : Charging / GREEN LIGHT ON : Fully Charged
6. Charger Trouble Shooting
(A) If LED (POWER) light is o
» Check the input voltage (115V/230V) is the same as you adjust.
» If light is still o, please check and repair the battery charger.
(B) If LED (CHARGE) light is o
» Check to see clips connection is correct.
» If the battery is fully charged, the LED (CHARGE) light will be o.
» If light is still o, the battery may be defective.
(C) If ORANGE light can turn to GREEN
» The battery can not be charged. Please check and recover it.
(D) If ORANGE light turns to GREEN immediately
» Check to see the battery is fully charged, if not, The battery may be defective Check and
recover it.
Figure 39
The time needed to recharge will vary depending on the depletion of the batteries.
Charging for longer than necessary will not harm the batteries. They can not be
overcharged.