CareCo Corvus Rapide - Trouble Shooting Corvus Rapide; Scooter Not Moving; Error Code Explanations; Common Problems and Solutions

26
9.TROUBLE SHOOTING
Here are some suggestions about solving problems you may have with your scooter. There
is a self-diagnostic warning light on the control panel. To check the self-diagnostic warning
light, turn on the key and count the number of blinks on the warning light.
9.1 SCOOTER WON’T MOVE WHEN KEY IN TURNED ON
Check point Solution
Check if the power is o Turn the power on.
Check if the N-D lever is in Neutral position
Switch to D (drive) position. Turn o the power and
turn on again.
Check if the battery power is enough. (Battery gauge
is under 25%)
Recharge the battery and then retest.
Check if the charger power cord is still plugged in
scooter
Unplug the charger power cord.
Flash Description Initial check points
E02 Low Battery Fault
The batteries have run out of charge.
» Recharge the batteries.
» Check the battery and associated connections and wiring.
E03 High Battery Fault
Battery voltage is too high. This may occur if overcharged and/or traveling
down a long slope.
» If traveling down a slope, reduce your speed to minimize the amount of
regenerative charging.
E04
Current limit time-
out or controller
overheat
The motor has been exceeding its maximum current rating for too long.
» The scooter may have stalled. Turn the controller o, leave for a few
minutes and turn back on again.
» The motor may be faulty. Check the motor and associated connections
and wiring.
E05 Park Brake
Either a park brake release switch is active or the park brake is faulty.
» Check the park brake and associated connections and wiring.
» Ensure any associated switches are in their correct positions.
E06 Drive Inhibit
Either a stop function is active or charger inhibits or OONAPU condition has
occurred.
» Release the stop condition (seat raised etc.)
» Disconnect the battery charger.
» Ensure the throttle is in Neutral when turning the controller on.
» The throttle may require re-calibration.
E07 Speed Pot
The throttle, speed limit pot. SRW or their associated wiring may be faulty.
» Check the throttle and speed pot and associated connections and
wiring.
E08 Motor Voltage
The motor or its associated wiring is faulty.
» Check the motor and associated connections and wiring.
E09 Other Error
The controller may have an internal fault.
» Check all connections and wiring.
9.3 OTHER PROBLEMS
9.2 ERROR CODE
» Tyre : Low tyre pressure: pump up tyres to 30~35 psi.
» Charger: During charging, light on charger doesn’t change to green. Please refer to section
6.1.