Carel boss - Programming parametric devices

12
+040000260 - 1.0 - 22.09.2017
ENG
9. Open the Main variables page.
10. In the Probes, status, inputs/outputs table choose
whether to make the variable visible and if so where
on the page (probe status section, general section).
Click É to compress the table.
11. The Parameters and commands table is shown:
repeat the same operation for the variables listed.
12. Click Save: the configuration will be saved but is not
yet active.
Note: to define the order in which the selected
variables are displayed, click Go to sort page
13. Open the Description list page.
14. Double click the variables to customise the code,
description and unit of measure.
15. Click Save: the configuration will be saved but is not
yet active.
3.4 Propagating the conguration to identical devices
The settings on the device chosen as the “sample” can be propagated to similar devices. This saves time when
setting up complex sites.
1. Under Conguration Æ Site conguration
Æ Copy conguration select the customised
device, choose which parts of the configuration
to propagate and choose the devices where the
settings will be copied.
Note: a complete configuration can be exported
and used on another site using the export function
Note: previously saved configurations can be loaded
using the import function.
2. Click Save: the recipient devices will be customised
with the specific configuration.
3. Restart the engine.