Carel EVD Evolution Twin - 12.3 Copying the setup; 12.4 Setting the default parameters; 12.5 Updating the controller and display firmware

ENG
“EVD Evolution TWIN” +0300006EN - rel. 2.6 - 31.01.2019
59
Fig. 12.f
Note: the program On-line help can be accessed by pressing F1.
12.3 Copying the setup
On the Congure device page, once the new project has been created, to
transfer the list of conguration parameters to another controller:
• read the list of parameters from the source controller with the “Read”
command;
• remove the connector from the service serial port;
• connect the connector to the service port on the destination controller;
• write the list of parameters to the destination controller with the “Write”
command.
Important: the parameters can only be copied between controllers
with the same code. Dierent rmware versions may cause compatibility
problems.
12.4 Setting the default parameters
When the program opens:
• select the model from the range and load the associated list of parameters;
• go to “Congure device”: the list of parameters will be shown, with the
default settings.
• connect the connector to the service serial port on the destination
controller;
• select “Write”. During the write procedure, the LEDs on the converter will
ash.
The controller parameters will now have the default settings.
12.5 Updating the controller and display
rmware
The controller and display rmware must be updated using the VPM program
on a computer and the USB/tLAN converter, which is connected to the device
being programmed (see paragraph 2.7 for the connection diagram). The
rmware can be downloaded from http://ksa.carel.com. See the VPM On-line
help.