BT2 user manual - H-5911-9004-02-B Page | 109
15.1.2 Connected
On detection of a Boretrak2 probe, Carlson Boretrak runs through checks to establish that communications with
the Boretrak2 are sound and to read information from the probe.
With all checks complete, a graphic of the Boretrak2 probe appears in the 3D View attached to the default Hole.
The Control tab becomes active, displaying deployment controls. These controls are outlined below.
15.2 Probe status
15.2.1 Connection button
The Connection button controls the Bluetooth connection between the Boretrak2 probe and the mobile device.
Tap Disconnect to manually disconnect from the probe. This control now becomes the Reconnect button.
During normal operations when the probe is deployed down a borehole, the probe will usually lose connection.
When the probe is recovered and is within range of the tablet, the Bluetooth link is automatically re-established. If
Figure 117 Control tab - Boretrak2 probe just connected
To Next Page
Loading...
Need help?
General
