Carlson BRx7 - Page 34

34 | Page
BRx7 User Manual
WebUI (connued)
Reference the following table for Working Mode elds and descripons:Working Mode
(connued)
Field Descripon
Cuto Angle Satellites at a lower angle to the horizon than
“5” are not used in the GNSS soluon.
GLONASS Enable or disable the use of GLONASS
satellites.
BeiDou Enable or disable the use of BeiDou satellites.
Galileo Enable or disable the use of Galileo satellites.
SBAS Enable or disable the use of SBAS for DGNSS
correcons.
L‐band Enable to use Atlas correcons or aRTK.
Atlas
Frequency
lf using Atlas, set to Auto to automacally tune
to the correct frequency, or manually tune to
the correct frequency.
Atlas Datum lf receiving Atlas correcons, you can use the
ITRF08 datum, the GDA94 datum, or input
custom X, Y, Z osets.
Note: This only aects Atlas posions.
RTK Timeout This eld indicates the amount of me an RTK
correcon will connue to be used aer RTK
correcons are lost.
Note: lf using aRTK, set the L‐band to Enable
and RTK Timeout should be set to 2700.