SP5014TRX MACHINE MAINTENANCE
24
Check cutter wheel, pockets, and teeth for
wear. If any repair is needed, see “Servicing
Cutter Wheel” section for further
instruction.
Always clean tip of grease gun fitting and grease fitting on machine before attaching hose
to prevent dirt from being forced into machine parts.
Grease jackshaft bearings daily. These
bearings should be purged using grease
EVERYDAY. Purge till new grease comes
out. Use Texaco
® Starplex II grease.
Always clean tip of grease gun fitting and
grease fitting on machine before attaching
hose to prevent dirt from being forced
into machine parts.
Grease cutter wheel bearings Daily. These
bearings should be purged using grease
EVERYDAY. Purge till new grease comes
out. Use Texaco® Starplex II grease.
Always clean tip of grease gun fitting and
grease fitting on machine before attaching
hose to prevent dirt from being forced
into machine parts.
Grease engine slide assembly every 15 – 20
hours of operation with approximately 2 to 4
shots of Texaco
® Starplex II grease. (Total
of 6 grease fittings.) DO NOT OVER
GREASE.
Grease engagement lever every 15 – 20
hours of operation with approximately 2 to 4
shots of Texaco® Starplex II grease.
ENGAGEMENT LEVER
GREASE FITTINGS
To Next Page
Loading...