Carrera impel - Walk Assistance (LED Multi)

EN-10Halfords Carrera Impel
5.6. Walk assistance
The walk assist mode can help you push your e-bike more easily, e.g. against a slope,
withamaximumspeedofupto6km/h(4mph).
You can only enable the walk assistance when the system is switched on and you are
pushing the e-bike.
• Long press and hold the “-” button on the console for two seconds to active the walk
assist mode.
• When walk assist mode activated, the assist level indicators on the console begin
blinking in a waterfall pattern toward the front of the bike.
• Press and hold the “+” button to start the walk assist. As long as you are holding the “+”
button, your e-bike will be propelled forward at a slow speed.
• Release the “+” button to stop pushing your e-bike.
• At the walk assist mode, if no buttons are pressed in 5 seconds, the walk assist mode
willautomaticallyturno󰀨forsafety.
⚠
WARNINGS
• The walk assistance function may only be used when pushing the e-bike; make sure
you are ready and stand steady before activating the walk assistance.
• Do not activate the walk assistance when you ride on the e-bike or if the wheels are
not in contact with the ground.
> 2 secs to active
<0.5secstoturno󰀨Long press to push the e-bike
Activated