Carrier 30HL - Placement

2" NPT
COOLER INLET.
1-3-1
EACH END
, HOLES
BETWEEN WATER CONN
__^ LIFTING AN GLES
1 ^ —3'-3|"
jf Cl POWER CONN I ^
ill □ i
B \HL)—--
I5"£NCL0SURE: width
- 4 '^ 5 §
^2“ DUV HOU FOR
8 I ELECTRICAL
7H CONTROL
^ DIAM(3) I CONNS
® KNOCKOUTS f
, BETWEEN MTG HOLES 025,030-
Tp — ^ I 0-11“
£_ 015,020 I
j^025,030 T
d MTG FRAME END
H HOLES
MTG HOLES
t COOLER
-3"—^
DIMENSIONS (ft-in.)
015.020
025,030
Length
Width
IIftTn^^
Inside
Cooler Inlet
Cooler Outlet
Cooler Drain
0- 1®/6
0- 61/2
0- 81/2
HL
6- 7%
2-10®/6
0- 15/6
0- 61/2
0 - 81/2
H L
9- 25/6
2-105/6
0-1
0- 65/8
0-4
■
TUBE PULL SPACE |
:-^
i
Cooler 1
6-0 6-0 !
7-0 i 7-0
Condenser I 6-6 j — 1 6-6 i —
H
_
6-21’/6 i
8-055/32
I 5-6/8
Fig. 1 — Unit Dimensions
3 CON DENSER SECTION-
JON HK UNITS ONLY
Table 1 — Weight Distribution (lb)
UNIT
30( )-
020 11787
025 11980
030
Location of mounting holes;
WATER
INLET
1
PLAN VIEW
1
END _ -1
^ ■ a
1 -
" + B
-1-
Fig. 2 — Compressor Mounting
To ensure safe moving, unit should remain on
shipping skid until final placement. If unit is moved
on rollers, use minimum of 3. Unit can also be
dragged into final position (must be on skid).
When rolling or dragging, apply force to the skid,
not the unit. Use care to avoid damage to piping and
control box.
PLACEMENT
When unit is in final position, remove skid, level
unit with a spirit level and bolt to floor or pad.
These units are not suitable for unprotected
outdoor use.
Carrier recommends that these units be located
in the basement or on the ground floor. However,
if it is necessary to locate unit on an upper floor,
be sure the structure has been designed to support
the weight. If necessary, add structural support to
floor. Also, be sure surface for installation is level.
Refer to Fig. I for space requirements and Table I
for weight distribution.
1090
2