Carrier 38MGQ - Installation of the Decoration Panel

22
INSTALLATION OF THE DECORATION PANEL
Detach the intake grill
1. Slide the two grille hooks toward the middle of the
decoration panel.
1 Intake grille
2 Grille hook
1
2
Fig. 41 --- Intake Grille
2. Open the intake grille and remove.
Fig. 42 --- Open Intake Grille
Install the decoration
panel
1. Align the indicate ””on the decoration panel to the indicate
““on the unit.
2. Attach the decoration panel to the unit with the supplied
screws as shown in Fig. 43.
1 Decoration panel
2 Screws (M5)(supplied with the panel)
1
2
Fig. 43 --- Attach the Decoration Panel
3. After installing the decoration panel, ensure that there is no
space betwe en the unit body and de coration panel. Otherwise
air may leak thr ough the ga p and ca use de wdrop (s ee Fig. 44).
Fig. 44 --- Eliminate Space
4. Mount the intake grille. Ensure that the buckles at the back
of the grille are properly seated in the groove of the panel.
Fig. 45 --- Mount the Intake Grille
5. Connect the two wires of the decoration panel to the
mainboard of the unit.
10-core wire5-core wire
Fig. 46 --- Connect two wires