Carrier 38MGQ - Installing the Indoor Unit; Indoor Unit Preparation

34
INSTALLING THE INDOOR UNIT
1. Preparation
S Open the front panel, remove the 4 screws and dismount
the front grille while pulling it forward.
Fig. 66 --- Remove the scr ews
Fig. 67 --- Remove the scr ews
S Follow the arrows to disengage the clasps on the front case
to remove it.
S Follow the procedure below when removing the slit
portions.
For Moldings
S Remove the pillars. Remove the slit portions on the bottom
frame using nippers.
3)Side
casings
2)Upper casing
3)Side
casings
Remove the pillar
Remove screws
Fig. 68 --- Remove the scr ews
For Side Piping
S Remove the pillars.
(1.) Remove the screws.
(2.) Remove the upper casing (2 tabs).
(3.) Remove the left and right casings (2 tabs on each
side).
(4.) Remove the slit portions on the bottom frame and
casings using nippers.
(5.) Return by following the steps in reverse order
(3>2>1).
Casing
Remove the pillar
Fig. 69 --- Remove the pillar
Casing
Remove the pillar
Bottom frame
Fig. 70 --- Remove the pillar
2. Installation
S Secure using 6 screws for floor installations. Do not
forget to secure to the rear wall.
S For wall installations, secure the mounting plate using 5
screws and the indoor unit using 4 screws.