– 16 –
EN
TH
7
Operating air conditioner without remote
controller (temporary operation)
In the following cases, the air conditioner can be operate without remote controller with temporary operation
button on the signal receiving unit.
• The battery in the remote controller expired.
• A trouble occurred on the remote controller.
• The remote controller has been lost.
1
Start
Push temporary operation button.
• The operation mode is the one last selected.
If you want to change it, turn the power off and
then on, and push the temporary operation
button again.
2 Stop
Push temporary operation button once more.
1
2
8
Wireless remote controller A-B selection
Using 2 wireless remote controllers for the respective air
conditioners, when the 2 air conditioners are closely installed.
Wireless remote controller B setup
1. Push the temporary operation button to start the air
conditioner.
2. Point the wireless remote controller at the indoor
unit.
3. Push and hold button on the wireless remote
controller by the tip of the pencil.
“00” will be shown on the display.
4. Push MODE button during pushing . “B” will
be shown on the display and “00” will be disappear
and the air conditioner will turn OFF. The wireless
remote controller B is memorized.
NOTE
• Repeat above step to reset wireless remote controller to be
A.
• The wireless remote controllers do not display “A”.
• The factory default of the wireless remote controllers is “A”.
CHK
CHK
“B” Display
“00” Display
32-EN31-EN
To Next Page
Loading...
