Page 32
Procedure Illustration
5) Disconnect the wires. Then remove the
electronic main box (CJ_OP_INV_011-
2).
6) Pull out the Electrical control box along
the direction indicated in right image.
to remove it (CJ_OP_INV_011-2).
7) The connector of each port is indicated
in right image. (CJ_OP_INV_013).
CJ_OP_INV_012
CJ_OP_INV_013
Note: This section is for reference only. Actual unit appearance may vary.
Main Board
Electronic Box
Swing Motor
Pipe Temperature Sensor
Display Board
Indoor Fan Motor
Terminals
Ground Wire
To Next Page
Loading...
