Page 33
3. Evaporator
Note: Remove the front panel and electrical parts (refer to 1. Front panel and 2. Electrical parts) before
disassembling evaporator.
Procedure Illustration
1) Disassemble the pipe holder located at the
rear of the unit (see CJ_OP_INV_014).
2) Remove the 3 screws on the evaporator
located at the fixed plate (see CJ_OP_
INV_015).
3) Remove the 2 screws on the evaporator
located at the base of the bearing side (see
CJ_OP_INV_016).
CJ_OP_INV_014
CJ_OP_INV_015
CJ_OP_INV_016
Note: This section is for reference only. Actual unit appearance may vary.
Pipe Holder
Screws
Screws
To Next Page
Loading...
