42
Fig. 52 — Single Point Installation
Fig. 53 — Wiring Diagram for Single Point Kit
Accessory When Required
Completing Heater Installation
1. Check electrical connections
2. Turn thermostat to OFF position.
3. Restore power to unit.
4. Check voltage supply and match the reading against unit and
heater nameplate.
5. Slowly turn thermostat up until fan comes on. First stage of
electric heat should be on depending on thermostat.
6. Continue raising thermostat until stage 2 comes on.
7. Set temperature to desired level or return thermostat to the
OFF position.
To Next Page
Loading...
