44
ECONOMIZER SYSTEMS
The unit may be equipped with a factory-installed or accessory
(field-installed) economizer system. Three types are available:
two with logic control systems (EconoMi$er
®
X and EconoMi$er
IV) and one without a control system (EconoMi$er2). See
Fig. 55-57 for component locations on each type.
Economizers use direct-drive damper actuators.
Fig. 55 — EconoMi$er X Component Locations
Fig. 56 — EconoMi$er IV Component Locations
Fig. 57 — EconoMi$er2 Component Locations
IMPORTANT: Any economizer that meets the economizer
requirements as laid out in California’s Title 24 mandatory
section 120.2 (fault detection and diagnostics) and/or pre-
scriptive section 140.4 (life-cycle tests, damper leakage, 5
year warranty, sensor accuracy, etc), will have a label on the
economizer. Any economizer without this label does not
meet California’s Title 24. The five year limited parts war-
ranty referred to in section 140.4 only applies to factory
installed economizers. Please refer to your economizer on
your unit.
Honeywell
HH79AH001
EconoMi$er X
Harness
Outside Air
Temperature Sensor
EconoMi$er IV
Controller (W7212)
Outside Air
Temperature Sensor
Low Ambient
Sensor
EconoMi$er2 Plug
Outside Air
Temperature Sensor
To Next Page
Loading...
