19
Daily schedule
On screens PH04, PH05 and PH06 three di erent daily schedules
can be created, each with a maximum of three time slots in which
the unit will be started. The unit will work inside and outside the
time slots with the type of schedule selected on the screen PH03.
For example:
Program 1: Slot 1: morning from 06:30h to 11:00h
Slot 2: morning from 11:30h to 13:30h
Slot 3: evening from 17:00h to 19:00h
Program 2: Slot 1: morning from 08:00h to 14:00h
Slot 2: evening from 17:00h to 20:00h
Program 3: Slot 1: morning from 07:00h to 15:00h
8 - TIME SCHEDULING
8.2. Scheduling: User terminal
With the User terminal enabled (optional), the schedule programming
of this terminal can be done.
This type of schedule does not appear in the screen selection.
To activate it press the key
for a few seconds. Access is gained
to a screen on which the forced running time is established.
Note: This forced start-up only can be done from the PH03 screen.
Weekly schedule
On this display, it is possible to assign a schedule program for each
day of the week.
The available options are:
1: schedule program No.1
2: schedule program No.2
3: schedule program No.3
0: no programming
PH12
Program selection
Daily start
M:1 T:1 W:1 T:1 F:2
S:3 S:0 -Mon- (0=off)
PH04
SCHEDULE PROGR. N.1
Slot1 > 06:30 to 11:00
Slot2 > 11:30 to 13:30
Slot3 > 15:00 to 19:00
PH06
SCHEDULE PROGR. N.3
Slot1 > 07:00 to 15:00
Slot2 > 00:00 to 00:00
Slot3 > 00:00 to 00:00
PH05
SCHEDULE PROGR. N.2
Slot1 > 08:00 to 14:00
Slot2 > 17:00 to 20:30
Slot3 > 00:00 to 00:00
Note: the start type “3 setpoints schedule + OFF of unit” has
its own schedule program defi ned on the screen PH13 (see the
previous section).
Creation of a schedule program
By pressing the key for a long time, the
terminal changes to the initial clock display
(CLOC).
Clock setting of the terminal
By pressing the key for a long time, the
terminal changes to the initial clock display
(CLOC).
From there, by pressing the
key, the
time update display is accessed.
The current time appears intermittently and
can be modifi ed with the help of the
keys. The new time can be validated with
the
key.
The minutes appear below intermittently.
Its value can also be modifi ed with the
keys and validated with the key.
There are two ways of returning to the main display: by repeatedly
pressing the key
or not acting on the terminal for some
seconds.
If it desired to abandon the programming,
by pressing the
key again, the terminal
changes to the exit display (ESC), which is
exited by pressing
.
Next, by pressing the key, the terminal
changes to the initial schedule program
screen (TIME BAND).
The User terminal has a scheduler that allows 6 time slots to be
chosen for each day of the week, indicated by the following icons
on the screen:
Note: the activation of both, the User terminal and its scheduler, is
carried out from the group of screens G. GENCONFIG (protected
by level 3 password).
A change in the setpoint temperature or the disconnection of the
unit can be scheduled in these time slots.
To Next Page
Loading...
