12. INSTALLATION ACCESSORIES
12.1 STANDARD INSTALLATION ACCESSORIES SUPPLIED FROM THE FACTORY
Wired Room Controller
With Accessories
To operate the air conditioner
used with indoor unit sizes
12K – 18K – 24K – 30K – 36K – 42K –
Wired Room Controller
With Accessories
1
To operate the air conditioner
used with indoor unit size 72K
Display & Receiver Panel
For Optional Wireless Remote
Control
1 To display operation and error codes
To illustrate control functions
of operation
To illustrate installation instructions.
Support angle for outdoor
unit Top discharge
4 To fix outdoor unit top discharge
12.2 OTHER INSTALLATION ACCESSORIES
Not supplied from the factory but must be used in the installation field to complete installation.
For fixing support angles with
outdoor unit top discharge
36K – 42K – 48K – 60K – 72K
For fixing support angles of
outdoor unit top discharge
with ground 36K–42K–48K–60K–72K
To electrically connect the indoor unit, the outdoor unit and circuit
Sealer putty
To fill the gap between the wall hole and the lump of refriger
lines, electrical connection cables and condensate drain line.
To tie together the refrigerant piping lines, electrical connection cables
and condensate drain line.
To stick pipe insulation.
To remove condensate water, from the indoor unit to the outside.
ـ Refrigerant piping lines
To connect refrigerant R410A between indoor and outdoor units
To insulate suction and liquid refrigerant piping lines
To adjust refrigerant charge for long refrigerant piping lines.
To secure the lump of refrigerant piping lines, electrical cables and
condensate drain line
To Next Page
Loading...
