Carrier ClassiCool 53KDMT12N-718 - Installation of Display and Receiver Panel

34
16. INSTALLATION OF DISPLAY AND RECEIVER PANEL
16.1 DESCRIPTION OF DISPLAY AND RECEIVER PANEL
1 2 3 4 5 6 7
1
MANUAL Button
* This button is used to operate the unit temporarily in case you misplace
the remote control or its batteries are exhausted.
* Onc
e you push temporary button, the air conditioner will run in such order :
Auto, Forced cool, off and back to Auto
AUTO
The OPERATION lamp is lit, and the air conditioner will run under AUTO mode.
The remote controller operation is enabled to operate a
ccording to the received signal.
FORCED COOL
The OPERATION lamp flashes, the air conditioner will turn to AUTO after it is enforced to cool
with a wind speed of HIGH for 30 minutes. The remote controller operation is disabled.
OFF
The OPERATION lamp goes o
ff. The air conditioner is OFF while the remote controller
operation is enabled.
2
OPERATION green led
* OPERATION green led lights on when the air conditioner operates
* OPERATION green led lights off when the air conditioner stops
3
TIMER green led
*
TIMER green led lights on when timer function operates
* TIMER green led lights off when timer function stops
4
DEF. / FAN red led
* This led lights on when defrost protection is activated and lights off
when defrost protection terminates in heat mode.
5
ALARM red led
ALARM red led flashes when there is a malfunction in outdoor unit
6
Infrared Signal Receiver
( In case of using remote control )
7
Display Digital Tube
* This display shows error code in case of a malfunction.