1. GENERAL NOTES TO INSTALLER
Ducted split air conditioner has been carefully designed and manufactured under strict Quality
Control conditions.
Therefore you are completely responsible for proper installation completion and operation of the
air conditioner.
Carefully read the manual carefully before proceeding with the installation to ensure correct
installation. This manual describes installation instructions to help ensure trouble free operation
and extended life of the air conditioner.
Make sure all accessory parts are with the system before beginning installation.
You will need the following tools for installation:
Phillips head screw driver
Electric drill, Hole core drill
Vacuum pump matched with Air conditioner R410A
Gas leak detector for refrigerant R410A
Important
• During the system installation make first refrigerant piping connections and then electrical
connections.
• If the system is uninstalled first disconnect electrical cables and then refrigerant piping
connections.
After completion of installation, perform a run test and give the customer full
instructions on the correct operation of the air conditioner including:
• Turning the unit on and off.
• Removal and cleaning of the air filters.
• Functions of the wired control.
• Re-installation of air filters after cleaning
Leave the owner manual with the customer so that it can to be used during operation of the air
conditioner.
Leave the installation manual with the customer so that it can be used for any service and
maintenance operations.
Advise the customer to the tips of energy saving while operating the air conditioner as
mentioned in the owner’s manual.
Warning
Disconnect the mains power supply switch before servicing the system or handling any internal parts
of the system.
To Next Page
Loading...
