Configuring the system
33CONNECTSTAT43 ©2022 Carrier.
Installation Guide All rights reserved.
21
Parameter Name/Description
NET GP OB MODE — Controls the O/B output over the BACnet network.
• DISABLED sets the Present_Value of the BACnet object to inactive and read-only and
the corresponding output relay will be in a de-energized state.
• ENERGIZED ACTIVE allows BACnet writes and energizes the output relay when the
Present_Value is ACTIVE.
• ENERGIZED INACTIVE allows BACnet writes and energize the output relay when the
Present_Value is INACTIVE.
DISABLED
DISABLED
ENERGIZED ACTIVE
ENERGIZED INACTIVE
DISCONNECT WIFI — Disconnects the thermostat from the Wi-Fi network.
CAUTION Disconnecting the Wi-Fi requires setting up the Connect Thermostat
using the Connect mobile application in order to re-establish Wi-Fi connectivity.
INSTALLATION TEST — See Installation Test (page 36) for detailed instructions.
RESTORE DEFAULTS — Press and hold the 5 button for 5 seconds to initiate and restore
all system setting defaults. Press the CANCEL button to go back to SYSTEM SETTINGS
screen.
To Next Page
Loading...
