Carrier i-Vu XT Router User Manual

i-Vu® XT Router (drv_gen5) CARRIER CORPORATION ©2022
Installation and Start-up Guide 26 All rights reserved
Primary Hub URI
Web address used to connect to the primary hub.
NOTE If you must use a proxy to reach the hub, enter proxy information on the
Advanced > Network tab.
Primary Hub Status
The state of the primary hub communication.
Failover Hub URI
Web address used to connect to the optional failover hub.
NOTE If you must use a proxy to reach the hub, enter proxy information on the
Advanced > Network tab.
Failover Hub Status
The state of the failover hub communication.
Advanced
Is Failover Hub?
Indicates if being used as a failover hub.
Listening Connection Type
When set as a failover hub, select interface type used to listen for connections.
Server Port
When set as a failover hub, enter the port on which the hub will be listening.
URIs
When set as a failover hub, this is the web address used by network devices to
connect to the hub. The URI is derived from the IP Port configured on the
Connections > Gig-E Port tab.
Minimum Reconnect Time
Initial number of seconds to wait before retrying a connect to a hub which
increases with each failure.
Maximum Reconnect Time
Maximum number of seconds to wait between connection retries to a hub.
Connection Wait Timeout
Number of seconds to wait for a hub to reply to a connection request.
Disconnect Wait Timeout
Number of seconds to wait for a hub to reply to a disconnect request.
Initiating Heartbeat Interval
Number of seconds to wait to send a heartbeat.
Accepting Heartbeat Interval
Number of seconds to wait to receive a heartbeat.
Certificate Management
Certificate table
See "To create or replace a BACnet/SC device’s operational certificate" in the
BACnet/SC Setup Guide for instructions on how to create the router’s operational
certificate, signed by the BACnet/SC network’s Certificate Authority.

Carrier i-Vu XT Router Specifications

General

Brand	Carrier
Model	i-Vu XT Router
Category	Network Router
Language	English