Carrier i-Vu XT Router User Manual

i-Vu® XT Router (drv_gen5) CARRIER CORPORATION ©2022
Installation and Start-up Guide 40 All rights reserved
To replace the fuse:
1 Turn off the router's power.
2 Remove the red power connector.
3 On both ends of the router, insert a small flathead screwdriver as shown below, and then gently pry up the
cover until it is released from the base.
4 Remove the cover from the base.
5 The fuse labeled F1 is located near the power connector. Use a fuse puller to remove the fuse.
6 Use the fuse puller to snap the new fuse into the fuse holder.
7 Replace the router's cover.
8 Replace the power connector.
9 Turn on the router's power switch.
10 Verify that the LED on top of the router is on.

Carrier i-Vu XT Router Specifications

General

Brand	Carrier
Model	i-Vu XT Router
Category	Network Router
Language	English