13 To create an identical schedule for another zone, skip ahead to
the Copying a Zone Schedule section in this manual, page 24.
NOTE: A default set of heating and cooling setback tempera-
tures, called UNOCCUPIED settings, may be activated by
pressing the HOLD button. "UNOCC" will appear in place of
"PERIOD" when the unoccupied settings have been activated.
UNOCCUPIED setting defaults can be changed in ADVANCED
SETUR page 34
Weekdays Schedule
You can program one schedule for Monday through Friday using the
WEEKDAYS screen.
1 Flip down the door at the bottom of the control.
2 Press the SCHEDULE button to access the schedule screen.
3 Select the zone you want to program by pressing the ZONE but-
ton until the correct zone name appears on the upper left screen.
Selecting "ALL ZONES" allows you to create one WEEKDAYS
schedule for the entire home.
4 If the word "WEEKDAYS" appears at the top of the screen, you are
ready to start. If not, press either the LEFT or RIGHT button as
necessary until "WEEKDAYS" is displayed. The WAKE time period
will be highlighted.
5 Using the TIME (+\-) button, set the start time for this time period.
6 Press the red HEAT button. Heating temperature will begin flash-
ing.
7 Set the heating temperature using the TEMP (+\-) button.
8 Press the blue COOL button. Cooling temperature will begin
flashing.
9 Set the cooling temperature using the TEMP (+\-) button.
To Next Page
Loading...
