CHANGE TIMER
10
3. Timer off time must be longer than
timer on time.
4. 0.5 second after setting, the wire
controller send information.the setting is
finished.
If there is a need of changing timer
time, press corresponding button to
revise it. If concel timer, change timer
time to 0.0.
The timer time is relative time,that is
delay after setting time( i, e: setting
time is 8:05 A,M). So when imer is set,
the standard time can not be adjusted.
8. TECHNICAL INDICA-
TION AND REQUIRE-
MENT
EMC and EMI comply with the CE
certification requirements.
NOTE
To Next Page
Loading...
Need help?
General
