62-11637 5–6
5.2.4 Component Test Mode
Component Test Mode allows the technician to energize individual circuits for 5 minutes at a time. The engine is
not allowed to start when the System is in Component Test Mode. Instructions for entering the Component Test
Mode are provided in Figure 5.5.
Figure 5.5 Component Test Mode
1. Enter the Technicians Menu, highlight COMPONENT TEST MODE and then press the “=” key as describe
in Figure 5.1.
2. Nine tests will be available. To scroll through the tests press the ▲ or ▼ key. The tests will highlight as the
list is scrolled. The available tests include:
3. With the desired test highlighted, press the “=” key. For example, if UNLOADER 1 is selected, the unloader
will come on, and “UNLOADER 1 OFF IN 5 MINUTES” will display. The minutes will count down to 0 at
which time the circuit will be de-energized, and the operator message panel will return to the test selection
screen.
4. To extend the test time, press the RESET TIMER soft key. The time will reset to 5 minutes. To stop the test
press the CANCEL/STOP soft key.
5. Continue as above to test additional components as required.
NOTICE
Technician Mode should be canceled when work is complete. If Technician Mode is not can-
celed, Technician Mode will be available for 60 minutes after the last key press without requir-
ing a code, even after placing the SROS in the OFF and then back in the RUN/STOP position.
6. Once activity requiring use of Technician Mode is complete, Technician Mode should be manually canceled,
refer to Figure 5.1.
BACK
EXIT
UNLOADER 1
UNLOADER 2
SV1
SV2
COMPONENT TEST MODE (1 OF 9)
2 & 3
UNLOADER 1 (MM output @ 3MM-6)
UNLOADER 2 (MM output @ 3MM-8)
SV1 (MM output @ 3MM-1)
SV2 (MM output @ 3MM-2)
SV4 (mm output @ 3MM-3)
Clutch Relay (MM output @ 3MM-11)
ENCU Power Circuit (Run Relay)
MM output @ 3MM-9
Engine Preheat (Glow Plug Relay)
MM output @ 3MM-14
Buzzer (mm ground @ 3MM-15)
2
RESET
TIMER
CANCEL/
STOP
UNLOADER 1 OFF IN 4 MIN
AMP DRAW: 2.0 AMPS
COMPONENT TEST MODE
4
4
To Next Page
Loading...
