Carrier ZS2-C series User Manual

ZS immersion temperature sensor
ZS Sensors Carrier Proprietary and Confidential CARRIER CORPORATION ©2017
Installation Guide All rights reserved
32
CAUTION
Allow no more than 0.06 inch (1.5 mm) bare communication wire to protrude. If bare
communication wire contacts the cable's foil shield, shield wire, or a metal surface other than the terminal
block, the device may not communicate correctly.
8 Close and latch the sensor's door.
9 Turn on the controller's power.
NOTE
Use the same polarity throughout the Rnet.

Carrier ZS2-C series Specifications

General

Brand	Carrier
Model	ZS2-C series
Category	Temperature Controller
Language	English