CHAPTER-VIII APPENDIX-I
A. INPUT CODES FOR THE DIGITAL MODULE
A.1 THE ALTERNATIVE KEY FUNCTIONS
A.I.I In this mode, the functions of three key are converted as below Fig. 1.
A. 1.2 "INC" -> This key does increase the number by one at current number.
And also any numeral can be increased from "0" to "F"(hexadecimal) A. 1.3 "SHIFT" -> This key shifts to the next
numeric digit. A. 1.4 "ENTER" -> This key saves the current code or revised code.
A.2 INPUT FOR WEIGHING CONDITION CODES
A.2.1 Set the scale to the calibration mode. A.2.2 Press the " ON/OFF " key (MODE 1).
-> The display is shown " C-SEt " and then "1-XX". A.2.3 Enter each weighing condition code. Refer to Table 1 through
Table 4
under 1 / 3,000 of external resolution.
THE CODES FOR HOLD VERSION
THE CODES FOR
STANDARD
VERSION
To Next Page
Loading...
