CAS AD series User Manual

CHAPTER-II THE CALIBRATIONS
A. SET THE CALIBRATION MODE
The CAL switch is located underneath of the hole left of the upper case.
1. Remove a seal cover.
2. Slide CAL switch to the CAL position.
3. Plug into the AC outlet.
-> The display shows "CAL" three times.

CAS AD series Specifications

General

Display	LCD
Readability	0.1g / 0.2g / 0.5g / 1g
Interface	RS-232
Operating Temperature	0°C to 40°C
Weighing Units	g, kg, lb, oz
Material	Stainless steel
Capacity	6 kg / 15 kg / 30 kg