CAS BI Series - Using, Keeping, and Battery Management; Using: Battery Preparation; Using: Power Switch Check; Using: Power On Procedure

USING
Replace the general(Mn, Alkaline)battery or charge the rechargeable
battery in full at using after long-time storage.
Open the top cover and check that the power switch in the left bottom
is ON as follows.
Power on by pressing ON/OFF key in the front panel.
Power switch and connector position
Ground
L/C Conn.
Main power S/W
Adapter Conn.
RS232C Conn.
Battery select S/W
Battery Conn.
+
+
+
CN4
BATT
RECHDRY
GND
NO
RELAY
CN3
IN
EX EX
CN2
RS232
KEEPING
Power off by pressing ON/OFF key.
Open the top cover and power off for a long-time storage.
BATTERY
Battery replacement or charging time
Power is off in a specific time after BAT signal flickers in the left
bottom of display part on using
Replace the general battery or charge the rechargeable battery.
General (Mn, Alkaline) battery using and replacing
Open the top cover and make as follows in the left bottom of
cover at using the general (Mn, Alkaline) battery.
Insert the battery into battery case after checking the battery
polarity.
19
All manuals and user guides at all-guides.com