How to fix 'current weight deviates from zero range' error on CAS CI-2001B?
If your CAS Accessories scale shows that the current weight deviates from the zero range, you can press the ZERO key. Note that this only works if the deviation is within 10% of the maximum capacity.
How to calibrate CAS CI-2001B if zero range deviates?
If the zero range deviates from the set range on your CAS Accessories scale, first confirm that there is nothing on the weighing platform. If the platform is empty, perform a calibration in CAL mode.
What to do if the tare weight exceeds the maximum capacity on CAS CI-2001B?
If the tare weight exceeds the maximum capacity of your CAS Accessories scale, set the tare to be smaller than the maximum capacity.
How do I resolve load cell connection issues in CAS CI-2001B Accessories?
To resolve load cell connection issues in your CAS Accessories device, check the load cell connector to ensure the signal polarity is correct. If the load cell is damaged, it should be replaced.
What should I do if the weight on the CAS Accessories platform is too heavy?
If the weight on the platform of your CAS Accessories scale is too heavy to be measured, do not load items that exceed the maximum tolerance.
What if load cell output is too low or high during SPAN calibration on CAS Accessories?
If the load cell output is too low or too high during SPAN calibration on your CAS Accessories scale, proceed with calibration again using less resolution.
What to check if load cell output is too high at ZERO calibration on CAS Accessories?
If the load cell output is too high at ZERO calibration on your CAS Accessories scale, check if the platform is empty. Then, proceed with calibration again after checking in A/D TEST mode.
How to troubleshoot printer connection errors on CAS CI-2001B?
To troubleshoot printer connection errors with your CAS Accessories device, check the printer connector.
General| Brand | CAS |
|---|---|
| Model | CI-2001B |
| Category | Accessories |
| Language | English |
To Next Page
