9
1.3 Installing the Label Roll
To install the label roll at any time you must follow the directions in this section.
Remove the printer front-cover and the printer side-cover. As you can see there is detailed
diagram affixed onto the inside of the printer side-cover. Use this diagram (or this manual) for
future reference on how to properly install the label roll. (See below fig.)
Find and remove the Label Roll Pin and the Pick-up Pin. Also find the Print Head Release
Lever and lift it upwards. Release the Print Head Release Lever and the print head will
automatically lift up. If there were any labels previously installed please remove all the
collected backing paper on the pick-up spool. Also remove the cardboard paper roll core if
there was a label roll previously installed. (See below fig.)
To Next Page
Loading...
