CAS PDN Series - OPERATIONS; Simple Weighing Mode

13
● Turn on the display by pressing power switch. Then, the display will show all
the segments and count up "0" to "9".
● When you turn on the display, make sure that platter is empty. Otherwise,
display will show "Err 1", an error of initial zero range. Please refer to "ERROR
MESSAGE" section for more information on page 14
●
When the weight becomes stable the display shows the stable sign (▼) on.
●
You may need to make it "0.000" by pressing key unless the display
indicate "0.000" under the empty platter.
1. Simple Weighing Mode
① Place a commodity on
the platter.
② Remove the commodity
from the platter.