CAS PDN Series - ECR Protocol Usage

16
4. How to Use ECR Protocol
4-1. ECR Port
1) Mode Setting
- If you select USB ECR, you will perform ECR communication through the USB port.
And in this case you can use printer(DEP, DLP) and BLE protocol.
- If you select RS232 ECR, you will perform ECR communication through the rs232 port.
And in this case you cannot use printer and BLE protocol.
- You can select different ECR protocols for RS232 and USB.
4-2. ECR Type
1) Mode Setting
- PDN can interface with most ECRs by selecting TYPE 0 to TYPE 15.
First of all, You must scale’s mode setting. Please refer to the page 10.
ECR
Type
Protocol
0, 1
Most P.O.S, ECRs and Some TEC P.O.S system
2
SHARP ER-Axxx, ER-A450T, New SANYO ECRs using RS-232, TOLEDO 3212, etc.
3
SHARP ER-Axxx, New SANYO ECRs using RS-232, TOLEDO 3212, etc.
4
CRS, NCR2170, SAMAUNG ER-5100, ER5115 and Many other ECRs
5
NCI General, SAMSUNG ER-5100, ER-5115, Most P.O.S System
6
Samsung ER-670
7
Samsung ECR(SPAIN)
8
Samsung ECR(PORTUGAL)
9
Some P.O.S System
10
Some P.O.S System
12
Most P.O.S System
13
Use in SOUTH AFRICA
14
Use in SOUTH AFRICA, Stream Data
15
Use in SOUTH AFRICA, Stream Data