CAS PDN Series - Setup Mode Access

15
3.SETUP MODE
3-1. How to Go to Setup Mode
Make sure that power is OFF. While pressing the ZERO key, press the power switch. The display shows
“U SEt”. You can select each menu by pressing the ZERO key and change the setting by pressing the TARE
key.
If you press ZERO key, you can save current setting and go next mode.
3-2. Set up Mode Table
No Category MENU SUB MENU DESCRIPTIONS
1
USB ECR
Type
“ typ xx”
Use USB port select ECR type 0~15
2
RS232
Communication
Mode
“r ECr”
(RS232 ECR)
“.typ xx”
Use RS232 port select ECR type
0~15
“ dEp ”
(DEP-50)
“ noSnd ”
No send protocol
“ K-snd ”
Push the key , Print out
(Command Mode)
“S-snd ”
Weight is Stable, Print out
(After zero return)
“ F-snd “
Print out, continuously (CAS22Byte)
“ dLp ”
(DLP-50)
“ noSnd ”
No send protocol
“ K-snd ”
Push the key , Print out
(Command Mode)
“S-snd ”
Weight is Stable, Print out
(After zero return)
“ bLE “
(BLE Protocol)
Use Bluetooth mode
Key Setting
Tare key- Change menu, change set data.
Zero key - Entering menu
※ I tal i c Bol d : D efaul t Setti ng
※ xx : ECR Type number