CAS SC Series - How to Set the Limit of Samples

13
Press the TOTAL key to check the total quantity
of samples.
Press the C key to clear this data.
(If you don’t want to clear this data, press the
TOTAL key.)
TOTAL C
Press the MODE key twice. Press the SET key.
MODE SET
Enter the upper limit quantity. (1000 PCS) Press the SET key to go to normal mode.
SET
1 0 0 0
6. How to Set the Limit of Samples
NOTE: When you count the samples, if the quantity of samples exceed the upper
limit(1,000 pcs), you will hear a beep sound and the count display will
blink. Then remove the samples and press the C key.
To delete this limit of samples, press the C key on step 3.