13
7. How to Set Auto Power Off
Auto-Power off function is to automatically power off as time is set. This
function is helpful to save battery, which is not in use. The following is the
setting procedure of Auto-power off.
When the scale is turned off
press key, holding
key. Then you will see the
"AP-10".(If you have set this
before,display will show
previous value.)
Press the key until the
display shows the "AP-x0"
that you wish to take.
(Refer to TABLE 1.)
Press the key, and then
the scale saves what you
programmed and shows all
the segments, counting up
"0" to "9".
DISPLAY FUNCTION
AP-00 This function does not automatically power off.
AP-10 This function does automatically power off when the scale is not in use for 10 minutes.
AP-20 This function does automatically power off when the scale is not in use for 20 minutes.
AP-30 This function does automatically power off when the scale is not in use for 30 minutes.
TABLE 1.
When you try to set the number of sample unit at the stage the display may show "LACK"
message shortly. The result of counting may be incorrect in the following cases.
a.unit weight 1/2
e *
b.
weight loaded 2% of maximum weighting capacity.
*"e" value may be various on capacity of product model.
Please refer to "SPECIFICATION" on page 15. For example, a product model
which capacity is 2.000kg has 1g as "e" value
859306-15-20 en ma 2012-07
To Next Page
Loading...
Need help?
General
