Casio 140CR-272 - 6. Troubleshooting; 140 CR; PCR-272

— 18 —
6.TROUBLESHOOTING
140CR
Symptom/Problem Mostcommoncauses Solutions
1 E01 appears on the display. Changing modes without
completing transaction.
Return mode switch to where it
stops buzzing and press
CA
=
AMT
TEND
.
2 E08 appears on the display. Sign on operation is not
performed.
Prior to starting registration of
any other operation, press ~
and then
%
CLK#
.
3 E94 appears on the display. Printer paper is jammed. Remove jammed paper. Turn
Mode switch to OFF then turn to
ON, or Turn power OFF and then
turn power ON.
4 No date on receipt.
Paper is not advancing enough.
Printer is programmed as a
journal.
Program printer to print receipts.
5 Drawer opens up after ringing up
only one time.
Department is programmed as a
single item dept.
Program the dept. as a normal
dept.
6 Not clearing totals at end of day
after taking report.
Using X mode to take out reports. Use Z mode to take out reports.
7 Programming is lost whenever
register is unplugged or there is
a power outage.
Bad or no batteries. Put in new batteries.
8 Register is inoperative.
Can’t get money out of drawer.
No power. Pull lever underneath register at
rear.
9 E90 appears on the display. Totals remain in the memory. Issue the general control reset
report, periodic reset report and
PLU reset report.
PCR-272
Symptom/Problem Mostcommoncauses Solutions
1 E01 appears on the display. Changing modes without
completing transaction.
Return mode switch to where it
stops buzzing and press
CA
=
AMT
TEND
.
2 E08 appears on the display. Sign on operation is not
performed.
Prior to starting registration of
any other operation, press ~
and then
%
CLK#
.
3 E94 appears on the display. Printer paper is jammed. Remove jammed paper. Turn
Mode switch to OFF then turn to
ON, or Turn power OFF and then
turn power ON.
4 No date on receipt.
Paper is not advancing enough.
Printer is programmed as a
journal.
Program printer to print receipts.
5 Drawer opens up after ringing up
only one time.
Department is programmed as a
single item dept.
Program the dept. as a normal
dept.
6 Not clearing totals at end of day
after taking report.
Using X mode to take out reports. Use Z mode to take out reports.
7 Programming is lost whenever
register is unplugged or there is
a power outage.
Bad or no batteries. Put in new batteries and program
again.
8 Register is inoperative.
Can’t get money out of drawer.
No power. Pull lever underneath register at
rear.