Casio 5602 User Manual

Viewing Step Count Data
PRO TREK Connected can be used to view
the information below, which is measured by
the watch.
●
Your step count and physical exertion over
the past 24 hours
●
Weekly number of steps, calories burned
1.
Y
Tap the “PRO TREK Connected” icon.
2.
X
Hold down (B) for at least two seconds
until the second hand points to [R] twice.
When a connection is established
between the watch and phone, [APP] will
change to [OK], and the second hand will
move from [R] to [C].
Trying to connect
Connection
successful
3.
Y
Follow the instructions on the screen to
display pedometer data.
Note
●
You can also use PRO TREK
Connected to specify a daily step
target.
●
Though the step count is displayed on
the watch in real time, PRO TREK
Connected displays step counts at the
time when a connection is established
between the watch and phone.
Because of this, the step counts
displayed by PRO TREK Connected
may be different from those displayed
by the watch.
Recording Your Current
Location (Location Memory)
You can use PRO TREK Connected to record
current location information.
1.
Y
Tap the “PRO TREK Connected” icon.
2.
X
Enter the Compass Mode.
l
Navigating Between Modes
3.
X
Hold (A) for at least five seconds until
[MEMORY] starts to flash. Release when
the second hand points to [R] twice.
If location information is successfully
acquired after a connection is established
between the watch and phone,
[MEMORY] will change to [OK], and the
second hand will move from [R] to [C].
●
[ERR] will appear on the display if
connection fails for some reason.
●
[FAILED]
n
[POSITION] will appear in
sequence if location information
acquisition fails for some reason.
Trying to connect
Connection
successful
4.
Y
Perform the operation shown on the
phone screen to view the Location
Memory information record.
●
You can have only one location record
in memory. Saving location information
while there is already a location record
in memory will overwrite the existing
record with the new information.
Note
●
If there is location information stored in
Location Memory, you can use
Location Indicator to check the
distance and bearing to the stored
location.
l
Checking the Distance and
Bearing to a Location Memory
Point (Location Indicator)
Checking the Distance and
Bearing to a Location
Memory Point (Location
Indicator)
The watch acquires current location
information from the phone, and then displays
the bearing and distance from your current
location to the location recorded in Location
Memory.
l
Recording Your Current Location (Location
Memory)
Bearing to memory point
Distance to memory point
Memory point
Important!
●
Note that PRO TREK Connected
operation is disabled while Location
Indicator is in use.
1.
Y
Tap the “PRO TREK Connected” icon.
2.
X
Enter the Compass Mode.
l
Navigating Between Modes
Operation Guide 5602
12

Casio 5602 Specifications

General

Brand	Casio
Model	5602
Category	Watch
Language	English