Casio 5602 User Manual

●
Interpreting Displayed Tide Conditions
The graph shows tide levels at the specified
port.
Current tide level at the specified port
High tide
Low tide
Falling tide Falling tideRising tide
Note
●
The graph shows tides for
approximately 12 hours as one of six
levels.
●
If the tide level is not being indicated
correctly, adjust the high tide time.
l
Adjusting High Tide Times
Checking the Tide Level for a
Specific Day
1. In the FISH Mode, display the current tide
information.
l
Navigating Between Modes
l
FISH Mode
2. Use (C) to change the date setting.
After about two seconds the display
switches to the time screen.
3. Use (C) to change the time setting.
The Tide Graph will show information for
the date and time you specify.
Adjusting High Tide Times
You can improve the accuracy of the
displayed high tide by adjusting the high tide
time in accordance with information available
on the internet or in a newspaper.
1. In the FISH Mode, display the current tide
information.
l
Navigating Between Modes
l
FISH Mode
2. Hold down (E) for at least two seconds.
Release when [SET] starts to flash and
then disappears from the display.
This displays the high tide time for the
currently selected date.
3. Press (D).
This causes the minutes digits of the high
tide time to flash.
4. Use (A) and (C) to change the high tide
time minute setting.
High tide time in the specified port
5. Use (D) to navigate between setting items.
Each press of the button cycles through
setting items as shown below.
High tide time minute
Longitude
Latitude
High tide time hour
Time offset
6. Press (E) to register the high tide time.
Note
●
For a location where there are two high
tides per day, set the time of the first
high tide. The watch will automatically
calculate the time of the second high
tide.
●
If the specified port is in a time zone
that is different from your current time
zone, there may be cases when the
date in the port is different from the
displayed date.
●
If summer time is in effect in the
specified port, you should also use
summer time when specifying the high
tide time.
Stopwatch
The stopwatch measures elapsed time in
1/100-second units for the first hour, and in 1-
second units after that for up to 24 hours.
It can also measure split times.
Operation Guide 5602
30

Casio 5602 Specifications

General

Brand	Casio
Model	5602
Category	Watch
Language	English